Polyether Polyol Manufacturing ProcessPolyether Polyol Manufacturing Process

 Synthesis of DMC-based polyether polyol by a continuous method

 

A certain amount of DMC catalyst is taken and uniformly dispersed in a certain amount of small molecule initiator. Add 0.5 kg of the mixture of the initiator in the small test reactor. The vacuum was replaced 1-2 times with N2, and the N2 pressure was maintained at 0.1 MPa. After heating, stirring and raising the temperature to a certain temperature, the quantitative PO was introduced into the continuous autoclave with nitrogen gas for induction. When the induction is successful (the temperature in the kettle rises and the pressure drops), the PO is continuously passed to carry out the reaction. Open the outer loop and continue to pass the PO into the continuous kettle.

 

When the liquid in the reaction vessel is full, the PO, DMC catalyst and the initiator are continuously added to the kettle at a certain ratio and a certain speed through the power system. Continuous discharge is started when a certain pressure is reached in the continuous autoclave. Keep the feed rate the same as the discharge rate until all the stock is added. The crude product discharged from the kettle enters the aging kettle, and is heated, matured, degassed, and discharged to obtain a finished product.

 

There are many polyether polyol manufacturers, but we are one of the best choices for you.

 

For more information about monoammonium glycyrrhizinate, please feel free to contact us!